Open eaves with trusses.
Eaves height flat roof extension.
For the purpose of measuring height the eaves of a house are the point where the lowest point of a roof slope or a flat roof meets the outside wall.
In the before pictures you can see where the chimney was capped off.
It made the house look odd as there are already lots of roof lines.
Would the council assess a side boundary wall of the extension for example being 4m high acceptable as pd parapet wall so long as the eaves height of the flat roof is only 3m high.
The materials used in exterior work except in the case of a conservatory.
If your extension is to be within 2m of your property s boundary the eaves height is limited to 3m.
The height of the eaves will be measured from the natural ground level at the base of the external wall of the extension to the point where the external wall would meet the upper surface of the roof slope.
Which means for a flat roof shed you can have an overall height of 3m with an eaves height of 2 5m.
The eaves are no more than 3 metres in height if any part of the extension is within 2 metres of the property boundary.
Open eaves with roof rafters before roof trusses the exposed rafter tails were an extension of the roof framing.
Where the extension comes within two metres of the boundary the height at the eaves cannot exceed three metres.
Some details sistered 8ft 2x6 to existing truss glued and screwed nailed.
Outbuildings and garages to be single storey with maximum eaves height of 2 5 metres and maximum overall height of four metres with a dual pitched roof or three metres for any other roof.
Or higher at the eaves than the existing eaves.
The measure from the bottom of the pressure treated splash plank to the intersection of the underside of the roofing at the outside edge of the sidewall columns.
The ceiling joists pushed the rafters up and gave extra height to the building.
Extension heights the pd criteria makes reference to an eaves height not exceeding 3m but a maximum height of 4m.
